Built with durable, all welded construction

Scrapers

The versatility of Rowse Scrapers allows you to move dirt, level land, dig holes, clear areas and drain or fill low spots. The complete operation is controlled by one single-spool, double-acting hydraulic control valve.

• Heavy-duty rectangular steel tubing frames
• 2¼" main hinge pivots
• 3-piece frost blade
• Removable and reversible 8' cutting blades

The Rowse Model 300 Hydraulic Scraper is designed for loading with smaller horsepower tractors but built tough for use with larger tractors, too. The scraper's 8' wide cutting edge is wider than its wheels, and when teamed with a single rear wheeled tractor, it lets you cut or fill close to existing structures or fences. The main hinge pivots are 2¼" cold rolled shafts with bronze bushings. Two double-acting hydraulic cylinders with 1½" chrome shafts position the scraper for loading, carrying and dumping. The 300 Model is available with two front wheels and other options.

The Rowse Model 500 and Model 700 Scrapers are designed for use with two or four-wheel drive tractors. Both have a gooseneck hitch to allow 90° turns for easy maneuverability.

• Rowse Scrapers feature heavy-duty rectangular steel tubing frames for strength and stability.
• The main hinge pivots are 2¼" cold rolled shafts with bronze bushings. Two double acting hydraulic cylinders with chrome shafts (2" Model 500, 2" Model 700) position the scraper bucket. A depth gauge is standard on the 500 and 700 models.
• A 3-piece frost blade attaches to a double reinforced bucket edge for maximum strength. The 8' cutting blades are removable on the 5 and 7 yard models, reversible and made with road grader-type steel. With fingertip operation from your tractor seat, the precise hydraulic control gives you an adjustable load or spread depth from 4"-12".
• The 500, 700, XL500, and XL700 scrapers are protected by a shear pin in the tongue should it strike an immovable object. All Rowse Scrapers are equipped with transport stops for safe transporting behind a pickup at highway speeds.

Scraper Specifications

Model 3002 • Model 3004

Model 5002 • Model 5004

Model 7002 • Model 7004

XL models in tandem

When you move a lot of dirt, the Rowse Tandem Model scrapers will keep you moving for years with a combined capacity of up to 14 cubic yards when heaped. Rowse builds Tandem Scraper Models XL500 and XL700. Both have standard 3-piece high carbon steel cutting edges with complete operation controlled by two double-acting control valves. The Tandem Models all have the same dependable standard features as the corresponding regular models.

The Tandem XL500 and XL700 Scrapers are equipped with dual rear wheels for stability and added weight capacity. A rear push bar for added loading is standard.

The gooseneck hitch of the rear scraper attaches to the 3" welded ball mounted inside the push bar. Very little additional horsepower is needed to operate the scrapers in tandem. Each scraper is loaded separately.

A depth gauge is standard on the 500, 700, XL500 and XL700 models. At a glance, the gauge indicates to the operator that the blade is at ground level for a more precise operation.

XL Specifications

Tandem models correspond to regular models with the following exceptions.

Model XL500

Model XL700